Click the link below to download the MSDS, or copy it from the text below.
MSDS for Fischer Technical Pump Oil
COMPANY: Fischer Technical Company
840 W. Lake Street
Suite 404
Roselle, IL 60172
Vacuum Pump Oil
December 28, 1992
Sept. 1, 2003
Distillates, hydrotreated heavy paraffinic
64742-54-7
This product is not approved for direct food use [CFR 178.3620 (a) & (b)]
Clear colorless to pale yellow liquid.
Not expected to cause prolonged or significant eye irritation.
Contact with the skin is not expected to cause prolonged or significant irritation. Not expected to be harmful to internal organs if absorbed through the skin. Contact with the skin is not expected to cause an allergic skin response.
Not expected to be harmful if swallowed.
Not expected to be harmful if inhaled.
Contains a petroleum-based mineral oil. May cause respiratory irritation or other pulmonary effects following prolonged or repeated inhalation of oil mist at airborne levels above the recomm ended mineral oil mist exposure limit.
Symptoms of respiratory irritation
may include coughing and
difficulty breathing.
No specific first aid measures are required because this material is not expected to cause eye irritation. As a precaution, remove contact lenses, if worn, and flush eyes with water.
No specific first aid measures are
required because this material is not
expected to be harmful if it contacts the
skin. As a precaution, remove clothing
and shoes if contaminated. To remove
the material from skin, use soap and
water. Discard contaminated
clothing and shoes or thoroughly
clean before reuse.
No specific first aid measures are required because this material is not expected to be harmful if swallowed. Do not induce vomiting. As a precaution, give the person a glass of water or milk to drink and get medical advice. Never give anything by mouth to an unconscious person.
No specific first aid measures are
required because this material is not
expected to be harmful if inhaled. If
exposed to excessive levels of material
in the air, move the exposed person to
fresh air. Get medical attention
if coughing or respiratory
discomfort occurs.
1910.1200): Not classified by OSHA as flammable or combustible.
0 1 0
Cleveland Open Cup 378°F (190°C)
(Min)
No data available
Use water fog, foam, dry chemical or carbon dioxide (CO2) to extinguish flames.
This material will burn although it is not easily ignited. For fires involving this material, do not enter any enclosed or confined fire space without proper protective equipment, including selfcontained breathing apparatus.
Highly dependent on combustion
conditions. A complex mixture of
airborne solids, liquids, and gases including carbon monoxide, carbon dioxide, and unidentified organic compounds will be evolved when this material undergoes combustion.
Eliminate all sources of ignition in
vicinity of spilled material.
Stop the source of the release if you can
do it without risk. Contain release to
prevent further contamination of soil,
surface water or groundwater. Clean up
spill as soon as possible, observing
precautions in Exposure Controls/
Personal Protection. Use appropriate
techniques such as applying noncombustible
absorbent materials or
pumping. Where feasible and
appropriate, remove contaminated soil. Place contaminated materials in disposable containers and dispose of in a manner consistent with applicable regulations.
Report spills to local authorities and/or the U.S. Coast Guard’s National Response Center at (800) 424-8802 as appropriate or required.
Avoid contaminating soil or releasing this material into sewage and drainage systems and bodies of water.
Electrostatic charge may accumulate and
create a hazardous condition when
handling this material. To minimize this
hazard, bonding and grounding may be
necessary but may not, by themselves,
be sufficient. Review all operations which
have the potential of generating an
accumulation of electrostatic charge and/
or a flammable atmosphere (including
tank and container filling, splash filling,
tank cleaning, sampling, gauging, switch
loading, filtering, mixing, agitation, and
vacuum truck operations) and use
appropriate mitigating procedures. For
more information, refer to OSHA
Standard 29 CFR 1910.106, ‘Flammable and Combustible Liquids’, National Fire Protection Association (NFPA 77, ‘Recommended Practice on Static Electricity; and /or the American Petroleum Institute (API) Recommended Practice 2003, ‘Protection Against Ignitions Arising Out of Static, Lightning and Stray Currents’.
Container is not designed to contain
pressure. Do not use pressure to empty
container or it may rupture with
explosive force. Empty containers retain
product residue (solid, liquid, and/or
vapor) and can be dangerous. Do not
pressurize, cut, weld, braze, solder, drill,
grind, or expose such containers to heat,
flame, sparks, static electricity, or other
sources of ignition. They may explode
and cause injury or death. Empty
containers should be completely
drained, properly closed, and promptly returned to a drum reconditioner or disposed of properly.
Consider the potential hazards of this material (see Section 3), applicable exposure limits, job activities, and other substances in the work place when designing engineering controls and selecting personal protective equipment. If engineering controls or work practices are not adequate to prevent exposure to harmful levels of this material, the personal protective equipment listed below is recommended. The user should read and understand all instructions and limitations supplied with the equipment since protection is usually provided for a limited time or under certain circumstances.
Use in a well-ventilated area.
No special eye protection is normally required. Where splashing is possible, wear safety glasses with side shields as a good safety practice.
No special protective clothing is normally required. Where splashing is possible, select protective clothing depending on operations conducted, physical requirements and other substances. Suggested materials for protective gloves include: Nitrile Rubber, Silver Shield, Viton.
No respiratory protection is normally required.
If user operations generate an oil mist,
determine if airborne concentrations are
below the OSHA Permissible Exposure
Limit (PEL) of 5 mg/m3 for mineral oil
mist. If not, wear a NIOSH approved
respirator that provides adequate
protection from the measured
concentrations of this material. For air-purifying respirators use a particulate cartridge.
Use a positive pressure, air-supplying respirator if there is potential for uncontrolled release, exposure levels are not known, or other circumstances where air-purifying respirators may not provide adequate protection.
Clear colorless to pale yellow liquid.
Not Available
>600°F (>315° C)
Soluble in hydrocarbons, insoluble in
water
NA
NA
2.9% weight (Approximate)
This material is considered stable under normal ambient and anticipated storage and handling conditions of temperature and pressure.
May react with strong oxidizing agents, such as chlorates, nitrates, peroxides, etc.
None known (None expected)
Hazardous polymerization will not occur.
The mean 24-hour Draize eye irritation score in rabbits is 4.0/110.
For a 24-hour exposure, the
Primary Irritation Score (PIS) in
rabbits is: 0.2/8.0.
This material did not cause skin sensitization reactions in a Buehler guinea pig test.
The 24 hour(s) LD50 in the rabbit is >5g/kg.
The LD50 in the rat is >5 g/kg.
The acute inhalation toxicity hazard is based on evaluation of data for similar materials or product components.
This product gave negative results in the following mutagenicity assays:
Microbial/Microsome Reverse Mutation Assay.
This product contains petroleum base oils which may be refined by various processes including severe solvent extraction, severe hydrocracking, or severe hydrotreating. None of the oils requires a cancer warning under the OSHA Hazard Communication Standard (29 CFR 1910.1200). These oils have not been listed in the National Toxicology Program (NTP) Annual Report nor have they been classified by the International Agency for Research on Cancer (IARC) as; carcinogenic to humans (Group 1), probably carcinogenic to humans (Group 2A), or possibly carcinogenic to humans (Group 2B).
Ten 96 hour(s) LC50 for rainbow trout (Oncorhynchus mykiss) is >1000 mg/l.
This material is not expected to be readily biodegradable.
Oil collection services are available for
used oil recycling or disposal. Place
contaminated materials in containers
and dispose of in a manner consistent
with applicable regulations. Contact your sales representative or local environmental or health authorities for approved disposal or recyling methods.
The description shown may not apply to all shipping situations. Consult 49CFR, or appropriate Dangerous Goods Regulations, for additional description requirements (e.g., technical name) and mode-specific or quantity-specific shipping requirements.
Not regulated as a hazardous material for
transportation under 49 CFR
Not Applicable
Not Applicable
Not Applicable
1. Immediate (Acute) Health Effects: No
2. Delayed (Chronic) Health Effects: No
3. Fire Hazard: No
4. Sudden Release of
Pressure Hazard: No
5. Reactivity Hazard: No
4_I1=IARC Group 1
4_I2A=IARC Group 2A
4_I28B=IARC Group 2B
05=NTP Carcinogen
06-OSHA Carcinogen
09-TSCA 12(b)
10=TSCA Section 4
11=TSCA Section 8(a) CAIR
12=TSCA Section 8(a) PAIR
13=TSCA Section 8(d)
15=SARA Section 313
16=CA Proposition 65
17=MA RTK
18=NJ RTK
19=DOT Marine Pollutant
20=PA RTK
21=TSCA Section 5(a)
25=CAA Section 112 HAPs
26=CWA Section 311
28=CWA Section 307
30=RCRA Waste P-List
31-RCRA Waste U-List
32=RCRA Appendix VIII
No components of this material were found on the regulatory lists above.