HIGH VACUUM PUMP PLATES, GAUGES, OIL, AND EXHAUST FILTERS

SCROLL DOWN TO VIEW ALL OF THE PUMP ACCESSORIES WE OFFER.

HIGH VACUUM PUMP PLATE

THE FISCHER TECHNICAL HIGH VACUUM PUMP PLATE IS MADE OF CAST IRON AND ACCOMMODATES BELL JARS UP TO 9" DIAMETER.  THE PLATE IS 1/2 INCH THICK AND NICKEL PLATED FOR CORROSION RESISTANCE.  THE HOSE BARB IS 3/8".  PUMP PLATE COMES WITH AN ATTACHED VACUUM RELEASE VALVE AND A RUBBER GASKET FOR A TIGHT SEAL.

PRODUCT NUMBER           

GA-001                             

ACRYLIC HIGH VACUUM PUMP PLATE

THE FISCHER TECHNICAL ACRYLIC PUMP PLATE ACCOMMODATES BELL JARS UP TO 9" WITH A 3/8" INTAKE PORT FOR VACUUM TUBING.  THE ACRYLIC BASE HAS FOUR SUCTION CUP STANDS AND THE PLATE IS 10.75" DIAMETER BASE X 1.5" HIGH.

PRODUCT NUMBER                   

AP-001                                   

HIGH VACUUM HAND HELD GAUGE

THE GAUGE FEATURES A DIGITAL DISPLAY WITH SOLID STATE CIRCUITRY.  THE VACUUM RANGE IS 25-12000 MICRONS.  IT WILL READ IN 7 INTERNATIONAL UNITES:  MICRONS, PSIA, InHg, mBARS, PASCALS, TORR, AND mTORR.  THE GAUGE WILL SAVE THE LAST READOUT AFTER SHUTDOWN AND HAS AN 800 PSI MAXIMUM PRESSURE TOLERANCE.  THE TOUCH BUTTONS ARE SEALED TO PROTECT AGAINST SPILLS AND DUST.  ONE 9 VOLT BATTERY  IS REQUIRED (NOT INCLUDED)

PRODUCT NUMBER                      

HVG-001                                          

HIGH VACUUM PUMP EXHAUST FILTER

THE PUMP EXHAUST FILTER ELIMINATES SMOKE FROM THE HIGH VACUUM PUMP EXHAUST BY REMOVING OIL MISTS.  THIS WILL PROTECT THE WORKING ENVIRONMENT, REDUCE NOISE LEVELS, AND MAINTAIN A RETENTION EFFICIENCY OF 99.9% AT .1 um WITH LOW FLOW RESISTANCE

PRODUCT NUMBER                       

LAV-EF                                       

HIGH VACUUM PUMP OIL

FISCHER TECHNICAL HIGH VACUUM PUMP OIL IS AVAILABLE BY THE QUART IN PACKS OF TWELVE.

PRODUCT NUMBER                       

OIL-001 (ONE QUART)                           

OIL-012 (CASE OF TWELVE)                       

HIGH VACUUM TUBING

THE FISCHER TECHNICAL HIGH VACUUM TUBING HAS AN ID OF 1/4 INCH AND CAN WITHSTAND 25 MICRONS OF PRESSURE; AVAILABLE BY THE FOOT OR IN A PRE-CUT FIVE FOOT SECTION WITH TWO HOSE CLAMPS.

PRODUCT NUMBER                       

HVG-TUBING (PER FOOT)                           

HVG-TUBING/SET (FIVE FOOT SECTION WITH TWO HOSE CLAMPS)